Connect Gas Supply - Weber Summit 56070 Guide De L'utilisateur

TEST CONNECTIONS
All connections and joints must be thoroughly tested for leaks in accordance with local
codes and all listed procedures in the latest edition of the National Fuel Gas Code ANSI
Z223.1/NFPA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane
Storage and Handling Code, B149.2, or the Standard for Recreational Vehicles, ANSI A
119.2/NFPA 1192, and CSA Z240 RV Series, Recreational Vehicle Code, as applicable.

CONNECT GAS SUPPLY

1) Uncap the flare fitting from the optional side burner connection located at
regulator.
Note: You must connect your side burner to a Weber
number #62434) located at main gas supply. If you do not use a Weber
regulator the Warranty on the Summit
have any questions, contact the Customer Service Representative in your area
using the contact information on our web site. Log onto www.weber.com
2) Connect the corrugated gas line to the side burner connection.
SIDE BURNER NG SUPPLY CONNECTIONS
1 Cap (Optional Side Burner)
2
3
4
a
WWW.WEBER.COM
®
INSTALLATION/GAS INSTRUCTIONS
CONNECTING GAS SUPPLY
® approved regulator (part
® Built-In Side Burner will be voided. If you
Hard Piped Gas Supply
Regulator
To SIde Burner
Top View
Do not use an open flame to check for gas leaks. Be sure
there are no sparks or open flames in the area while you
check for gas leaks. This will result in a fire or explosion
which can cause serious bodily injury or death, and damage
to property.
® approved
® .
2
2
DANGER
a
1
3
a
4
3
11