Kicker Front Row ZXDSP1 Manuel D'utilisation page 3

The Front Row has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo's source unit. A high-level signal can be run from the source unit's speaker outputs to
the stereo RCA inputs on the end panel of the Front Row using the KICKER ZISL as shown on the next page.
Alternatively, the signal can be delivered to the Front Row using the low-level RCA outputs on the source unit.
Keep the audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this
wiring, cross it at a 90 degree angle.
core conductor
source unit
high-level speaker
outputs
+
–
Install a 2A fuse within 18" (45cm) of the battery and in-line with the power cable connected to your Front Row.
If you ever need to remove the Front Row from the vehicle after it has been installed, the ground wire should be
the last wire disconnected from the Front Row--just the opposite as when you installed it.
NOTE: Use 18 gauge
or larger wire for these
four connections.
To vehicle
+12V constant
bare-metal
chassis ground
Do not remove the diagnostics
and fi rmware port cover. Do not
connect any devices. KICKER is
not responsible for any damage
to the Front Row or devices that
have been connected to this
port.
2012 FrontRow (ZXDSP) Rev G.indd 3 2012 FrontRow (ZXDSP) Rev G.indd 3
to amplifi er
shield
remote turn-on
in and out
KICKER ZISL
OR
source unit high-level
speaker outputs
Pro Tip: To get the best
performance from your new
KICKER gear, use genuine
KICKER accessories and
wiring.
mount the Front Row to the
vehicle using the supplied screws
to amplifi er
3
4/30/2012 1:55:46 PM 4/30/2012 1:55:46 PM