Battery Instructions; Connecting Conditions - Multi-Mover LA-MM6 Mode D'emploi

4. BATTERY INSTRUCTIONS

Just after some charge cycles and usage, new batteries will get full capacity. Keep this
in mind at the first trip.
After every trip, the batteries can be charged.
Charging overnight is possible.
Just when the green LED lights, the batteries may be disconnected from the charger. Only
if very necessary, the charge cycle may be interrupted (at first disconnect the mains
cable, at second disconnect the charge cable). In this case keep in mind, that the batteries
are not full, and you can not ride a far distance.
If the green LED lights and the batteries are not disconnected, the battery is kept in
optimal full state.
If batteries are not frequently used, it is recommended to charge the batteries at least
once a month (due to the self-discharge of the batteries). It is also possible to let the
batteries continuously connected to the charger.
Although the charger can charge deep discharged batteries, it is recommended not to
discharge batteries very deep, because this shortens battery life. However, if this
happens, it is recommended to charge the batteries as soon as possible in order to reduce
battery damage.
The charger has been adjusted for only one battery type and capacity. If an other battery is
connected to the charger, this battery can be damaged and/or dangerous situations may
occur. Therefore if batteries are changed, you must contact your supplier/dealer, to adjust
the charger to the correct battery type and capacity.
In case of any questions, you can contact your supplier/dealer
5. SETUP OF THE CHARGER
When placing the charger it should be observed that it has sufficient ventilation all around.
A space of at least 10 cm should be allowed. If there is not sufficient ventilation or the
temperature is high, the charger will lower the output current (resulting in longer charge
time) or if the temperature rises over a maximum value, the charger will stop charging.
The cabinet is made of plastic and suitable as a table model.
During normal operation the housing is getting warm. This is normal.

6. CONNECTING CONDITIONS

6.1 Connection to 1-phase network
The charger is suitable for a mains voltage of 230V - 50/60Hz, 1-phase and has been
fitted with a 1.9 meter mains lead and plug.
NOTE: Check whether the mains voltage is in accordance with the voltage the charger
was designed for.
The mains plug should be plugged into a wall socket.
23