Unitec 77 089 Mode D'emploi page 5

77089 Bed.:Lay 17.05.2010
Operating and safety instructions
Please bear in mind that, due to its dimensions, this LED position light is also
suitable to be installed on the two-wheeler. In doing so, please fit the light in
close proximity to your usual position/side light, which you must disconnect
after installation. Please bear in mind that the maximum installation height on
the two-wheeler is 1200 mm. The min. installation height is 350 mm. Further-
more, please note that the light should be installed symmetrically in the middle
of the vehicle. In case of uncertainty, please consult your service centre.
• Suitable for 12 Volts
• Power consumption 2 x 1.6 Watt
• Dimensions: W 13 cm x D 4 cm x H 2 cm
Due to the E certification you do not need any registration nor any general
operating permit (ABE).
Do not dispose of this product in the domestic waste at the end of its useful life.
You can find out more details from your official disposal body. Do not dispose of
the battery in the domestic waste but take it to the special waste disposal point.
For cleaning use only water, mild soap and a soft cloth. Do not use any solvents
such as spirit or petrol. Solvents may corrode the material.
12:17 Uhr Seite 5
⊕
red
⊖
black
Installation on
the two-wheeler
Connection diagram
Technical specifications
Registration
Disposal instructions
Cleaning
5