NSS AERO PLUS Instructions D'origine page 4

NOISE
Sound pressure level at 8ft [2.4m].
GENERAL INFORMATION
 Now that the machine is unpacked remember to
recycle all packing materials.
 Inspect the machine for damage or missing
components. If damage is found, contact the
local freight company to file a freight claim.
MACHINE OPERATION
Cord
 Unwrap cord from built in cord wrap.
 Plug into a properly grounded outlet.
Positions
This machine may be operated in four (4) different
positions.
 Flat for drying floor and carpet.
 With front kickstand down for indirect floor
drying.
 45° for drying walls, furniture, floor waxes and
sealers.
 90° for drying ceilings.
Large Areas
 The aero can be stacked up to three (3) units
high for higher volume or increased airflow for
larger areas.
Fan Speeds
This machine has three (3) ranges of speed.
 LOW: To Dry waxes and sealers on bare floors.
Use the 45° position.
 MEDIUM: To dry medium size areas - avoids
moving papers on desks.
 HIGH: To dry large open areas.
Speed Drying Of "Wall To Wall" Carpet
 All furniture should be removed from the room.
OPERATION MANUAL
AERO PLUS
 Peel one of the corners of the carpet back. A
scratch awl or any pointed instrument will make
65 dB(A)
this easier.
 Position the fan so that the exhaust snout is
under the carpeting pointing toward the center of
the room.
 Be sure the intake screens are not blocked.
 Plug into a grounded outlet and turn switch to
desired speed. Fan forces air under and through
the carpet to speed drying time.
 Carpet will billow in the center of the room.
 Remove fan when dry and stretch carpet back
into place.
MAINTENANCE
Routine maintenance is critical to ensure proper
machine operation and cleaning performance.
Perform all maintenance procedures as follows:
WARNING: Always unplug machine before
performing any maintenance. See front page
for warnings.
Daily Maintenance
 Inspect the cord and plug for any damage.
Yearly Maintenance
 Contact NSS authorized repair service center to
 Inspect cord and plug for any damage.
 Inspect switch for proper operation.
 Inspect unit for rubbing of fan.
 Lubricate motor with light oil .
OPTIONAL EQUIPMENT
An optional Wheel/Handle kit part number
4793011 is available to transport the machine.
Only use genuine NSS accessories with this
machine.
To prevent damage to the AC power cord,
ALWAYS store the machine with the AC power
cord coiled loosely over the machine.
perform service.