Connecting To A Bluetooth Device - LENCO PA-325 Mode D'emploi

2. Insert the mains cord into the connection socket AC IN of the Bluetooth
as illustrated.
3. Plug the mains plug into an accessible wall socket and switch the power switch to ON.
The CHARGE INDICATOR light flashes red at short intervals. When the battery is empty, it
normally takes around 6 hours to fully charge it. Once the rechargeable battery is fully
charged, the charging indicator light will turn green.
The playback time via Bluetooth
disco ball is switched on/off, etc.).
• You can use the sound system while it is charging. However, this will
increase the charging time.
• To preserve the rechargeable battery's full capacity for as long as
possible, you should fully recharge the battery at least once a month, even
if you do not use the sound system.
• Charge the battery in an environment between +10 and +40°C.
• The battery will best hold its charge at room temperature. The lower the
surrounding temperature, the shorter the playback time.
• The battery needs to be recharged if the CHARGE INDICATOR light turns
red.
Connecting to a Bluetooth® device
When power on the Bluetooth sound system, the Bluetooth indicator is flashing.
• You may be required to enter a password. If so, enter 0000.
• Always refer to the instruction manual for your mobile device.
• The audio cable must not be inserted into the AUX INPUT connection socket.
® is at least 5 hours (depending on the volume and if the
®
sound system