Battery Charge Level - Batavia MAXXPACK BT-CLC003 Mode D'emploi

English
Note: Make sure the battery and machine are lined up cor-
rectly. If the battery does not slide onto the machine easily,
don't force it. Instead, remove the battery; check the top of
battery and the machine slot are clean and undamaged and
that the contacts are not bent.
2.5
WARNING: Failure to follow the correct procedure when
charging batteries will result in permanent damage.
a. Plug the charger plug into an electrical outlet. The red
b. Slide a battery (1) onto the battery charger (4).
c.
d. When the battery is fully charged, the green LED (6) will
Note: Make sure the battery and battery charger are lined up
correctly. If the Battery does not slide onto the battery
charger easily, don't force it. Instead, remove the battery;
check the top of battery and the battery charger slot are
clean and undamaged and that the contacts are not bent.
Attention: When both LEDS (green and red) are flashing
during charging, this means that the battery has overheated
or there is a defect in the battery. In this case, remove the
battery from the charger immediately.
2.6
The battery has a built-in charge indicator. Pressing on the
button (3) to the right will indicate the charge level. The right
LED indicates a high charge level and the left a low charge
level that will mean the battery pack will require charging
soon.
IMPORTANT: When a low charge level is indicated be aware
the tool may stop operating while using the tool. In some
instances this may be dangerous. It is recommended to
always ensure the battery pack has a good charge level.
8
63554-4Ah-Charger-Maxxpack-Ma-1812-04.indb 8
Charging the Battery
LED indicator (5) on the charger (4) will lighten up.
Once charging commences, the red LED (5) will illumi-
nate and the green LED (6) will flash.
illuminate.

Battery Charge Level

20-12-18 11:3