Monster Power High Definition PowerCenter HDP 2500 Manuel Du Propriétaire page 19

Symptom Possible Cause
The Unswitched LED on The PowerCenter is not plugged in.
front panel is Off.
The PowerCenter is plugged in but the outlet is not
receiving power.
The Switched LED is Off. You are using the Switched Outlet Remote Turn-
On feature and haven't plugged the plug into the
component you wish to use to activate the Remote
Turn-On.
The component remote control you are using to power
the Remote turn-on has a dead battery.
The component you wish to use to activate the Remote
Turn-On isn't plugged into a properly grounded 120 volt
(nominal) outlet.
TROUBLESHOOTING
Remedy
• Plug the PowerCenter into a properly grounded 120 volt (nominal) outlet and make
sure it is on.
• Plug the plug into the component you want to use to activate Remote Turn-On..
• Replace the battery powering the component remote control.
• Plug the component into a properly grounded 120 volt (nominal) outlet.
• Plug the PowerCenter into a properly grounded 120 volt (nominal) outlet.
13