Mounting The Device - Velleman HQ-Power VDL1200SM2 Mode D'emploi

 Fog machine are not designed for permanent operation: regular operation breaks will prolong
their lives.
 Do not shake the device. Avoid brute force when installing or operating the device.
 Select a location where the device is protected against extreme heat, dust and moisture.
 Use an appropriate safety cable to fix the device (e.g. VDLSC8).
 Familiarise yourself with the functions of the device before actually using it. Do not allow
operation by unqualified people. Any damage that may occur will most probably be due to
unprofessional use of the device.
 Use the original packaging if the device is to be transported.
 All modifications of the device are forbidden for safety reasons.
 Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Overview
5.

Mounting the Device

 Have the device installed by a qualified person, respecting EN 60598-2-17 and all other
applicable norms.
 The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
 When choosing a location for your device, make sure to avoid a location exposed to vibrations,
dust, hot and cold temperatures, and dampness. In addition, no powerful transformers or motors
must be set up close to the device.
 When installing or setting up the device, make sure that neither the power cable nor the remote
control cable is squashed or damaged by any sharp edges.
 Make sure there is no flammable material within a 0.5 m radius of the device.
 Make sure the fog outlet is not directed towards persons, animals or open fires. The discharged
hot vapour can cause burns (keep a safety distance of min. 0.5 m).
 To ensure sufficient ventilation, keep a minimum distance of approximately 20 cm to other
objects around the device and do not cover the ventilation openings.
 Always place the device on a stable surface. The device must be operated in a horizontal position
(max. tilt of 15°) so that the tank does not lose fluid when it is filled or operated.
 Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
 Have a qualified electrician carry out the electric connection.
 Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
 The installation has to be approved by an expert before the device is taken into service.
6. Use
Warning: Make sure that the tank never runs empty during operation. If it does run empty,
immediately switch off the fog machine via the power switch and allow it to cool down. You can
check the liquid level on the back of the device (see Overview above).
V. 03 – 21/01/2015
VDL1200SM2
1 ON/OFF button
2 liquid level gauge
3 wire controller connector
4 power cord
3 ©Velleman nv