Cleaning The Accessories - Gima CORSIA Mode D'emploi

SYMBOLS
Class II isolation equipment
CE marking in conformity with EC directive 93/42/EEC
Manufactured by: CA.MI. snc di Attolini Mario & C.
Via Ugo La Malfa nr.31 – 43010 Pilastro (PR) Italy
Warning, consult the instruction manual
To Preserve in place coolness and dry land
Conservation temperature: -25 ÷ 70°C
Type B equipment
Fuse
~ Alternate Current
Hz Mains Frequency
I ON
O OFF
CLEANING DEVICE
Use a soft dry cloth with not – abrasive and not – solvent detergets.
MAKE SURE THAT INTERNAL PARTS OF THE APPLIANCE DON'T COME INTO CONTACT WITH LIQUIDS AND THE
PLUG IS NOT INSERTED

CLEANING THE ACCESSORIES

Procced as follows to disinfect the accessories:
1. Turn the upper part of the nebulizer in an anti-clockwise direction;
2. Disconnect the internal pisper at the base of the nebulizer using the fingers;
3. Use denatured alcohol or a hypochlorite - based solution, easily found at chemist, to clean the accessories;
4. After using the appliance, disassemble the nebulizer and clean all parts in warm water, rinse carefully and remove excess
water using a soft cloth and leave to dry in a clean place.
DO NOT BOIL OR PUT IN AUTOCLAVE THE ACCESSORIES
After each treatment clean thoroughly each component of the nebulizer (except air tube) removing medication residual and
possible impurities. Clean all parts in warm water.
Rinse thoroughly making sure that all deposits are washed away and let dry.
12