Wiring The Light - Bigass BAS-HPF1-12 Série Manuel D'installation

Refer to the input voltage rating marked on the fixture, and then
wire according to the diagram and table below. NOTE: The dimming
cable is not included if an occupancy sensor is purchased with the
fixture.
POWER
L1
L2
GROUND
Supply voltage
120 VAC, 1 Ф derived from
1 Ф, 240/120 V panel
208 VAC, 3 Ф derived from
3 Ф, 208/120 V panel
240 VAC, 1 Ф derived from
1 Ф, 240/120 V panel
240 VAC, 1 Ф derived from
3 Ф, 240/120 V panel, B phase
wild
277 VAC, 1 Ф derived from
3 Ф, 480/277 V panel
347 VAC, 1 Ф derived from
3 Ф, 600/347 V panel
480 VAC, 3 Ф derived from
3 Ф, 480/277 V panel
480 VAC, 1 Ф derived from
3 Ф, 480 V panel, corner ground
4
HIGH POWERED FIXTURE

WIRING THE LIGHT

FIXTURE
L1 (BLACK IN US/CA;
BROWN OUTSIDE US/CA)
L2 (WHITE IN US/CA;
BLUE OUTSIDE US/CA)
GROUND (GREEN IN US/CA;
GREEN W/ YELLOW OUTSIDE
US/CA )
Fixture's L1 (black)
connects to
H (black)
L1 (black), L2 (red), or L3
(blue)
L1 (black)
L1 (black), L2 (orange), or
L3 (blue)
L1 (brown), L2 (orange), or
L3 (yellow)
L1 (red), L2 (black), or L3
(blue)
L1 (brown), L2 (orange), or
L3 (yellow)
L1 (brown) or L3 (yellow)
© 2016 BIG ASS LIGHT, LLC
DIM+
(VIOLET)
DIM-
(GRAY)
Fixture's L2 (white)
connects to
N (white)
L2 (red), L3 (blue), or L1
(black)
L2 (red)
L2 (orange), L3 (blue), or
L1 (black)
N (white)
N (white)
L2 (orange), L3 (yellow),
or L1 (brown)
L2/Grounded conductor
(white or gray)
ALL RIGHTS RESERVED
DIMMING
(1–10 V DC)
DIM+
(VIOLET)
DIM-
(GRAY)
WWW.BIGASSLIGHT.COM