Bigass BAS-HPF1-12 Série Manuel D'installation page 5

WARNING: Proper cable installation is required for safety.
!
Ensure cables are taut to support the fixture.
1. Secure cables to fixture
Loop the cables through the eye bolts and secure with Gripple
fasteners as shown on the front page of this guide. Pull to adjust
length and tension. Note: To back a cable out of a Gripple, insert a
0.05" Allen wrench into the small hole in the Gripple.
2. Secure cables to structure
Route the free end of each cable through a Gripple, around the
mounting structure, and then back through the Gripple. Hang the
fixture at least 2 ft (61 cm) from the ceiling. Pull to adjust the length
and tension.
3. Pendant installation (Optional)
Run the power supply wiring through (customer-supplied) 3/4"
conduit and secure conduit at outlet box. Connect wiring and secure
conduit to the fixture. Adjust the tension of the cables to provide
safety support.
HIGH POWERED FIXTURE
HANGING THE LIGHT
© 2016 BIG ASS LIGHT, LLC ALL RIGHTS RESERVED WWW.BIGASSLIGHT.COM
3