Fitting/Removing Attachments; Before First Use - Nevadent NMD 3.7 A1 Mode D'emploi

NOTE
► Do not charge the appliance if there is water in the water tank

Fitting/removing attachments

■ To fit an attachment
and press the attachment
■ To remove an attachment
and pull the attachment
NOTE
► To order new attachments
(see section "Service"). Have the IAN number of this appliance to hand.
You will find the IAN number on the front page of these operating in-
structions as well as directly under the service addresses and on the type
plate of the appliance.
► You can also use the replacement nozzles for Panasonic
(model EW 1211 W).
► *Panasonic is a registered trademark of the Panasonic Corporation.
■ Attachments
on the charger
Before first use
1) Rinse the attachments
into one of the recesses
onto the handset.
2) Pull the water tank
tank
3) Push the water tank
tube is in the water tank
4) Fill the water tank
5) Hold the handset so that the nozzle
However, do not tip the hand set too far, otherwise the supply tube will
no longer be able to reach the water or water will leak from the air supply
slit .
NMD 3.7 A1
to the handset, push it into the attachment fitting
upwards off the appliance.
that are not in use can be placed in one of the recesses
.
in clean water. One attachment
on the charger
downwards off the appliance and rinse the water
in clean water.
back onto the appliance. Ensure that the supply
.
as described in the section "Filling the water tank".
downwards so that it clicks into place.
from the handset, press the release button
, please contact the service department
. Fit the other attachment
is pointing into the wash basin.
.
®
* oral irrigators
can be placed
│
GB 37 ■