Bosch SHX5AV55UC Guide D'utilisation page 19

Delay Start
For models with a display, you can delay the start of the cycle in one hour increments up to 24 hours.
For models without a display, you can delay the start of the cycle in three hour increments up to 9
hours.
To set delay start:
1
Press the [On/Off] button.
2
Press the [Delay] button until the display jumps to "h:01" or the corresponding LED blinks.
3
Press the [Delay] button until the displayed time corresponds with your requirements. For models
with a display, the display can be interpreted as follows:
h:01 = 1 hour delay
h:24 = 24 hour delay
4
Press [Start] to activate delay start.
To cancel delay start:
1
For models with a display, press the [Delay] button until "h:00" is indicated on the digital display.
For models without a display, press the [Delay] button until no LEDs are blinking.
2
Press and hold [Start] for 3 seconds to cancel the cycle. You may now start a new cycle.
Cycle Completion Signal
1
Press the [On/Off] button.
2
Hold down the "A" button (see page 15) and press [Start] until the display indicates "d:00".
Release both buttons.
3
Press the "A" button until the display shows "b:02" for models with a display. For models without
a display, the "Clean", "Sanitized", and "Add Rinse Aid" LEDs are all blinking.
4
Press the "C" button to increase or decrease the tone. See settings below:
"b:00" or 0 LEDs blinking = Cycle Completion Signal OFF
"b:01" or 1 LED blinking = Low tone volume
"b:02" or 2 LEDs blinking = Medium tone volume
"b:03" or 3 LEDs blinking = High tone volume
5
Press [Start] to save setting.
Infolight®
NOTE: Setting can only be changed for models with a display.
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the
LED is not visible.
To change the setting:
1
Press the [On/Off] button.
2
Hold down the "A" button (see page 15) and press [Start] until the display indicates "d:00".
3
Release both buttons.
4
Press the "A" button until the display shows "1:01".
5
Press the "C" button to switch between "1:01" = ON and "1:00" = OFF and press [Start] to save.
17