Amplicom RingFlash 100 Mode D'emploi page 29

Using the Doorbell
(RingFlash 200 only)
Press the Doorbell button, the red
light in the button will turn on. The
RingFlash unit will sound the Doorbell
tone that you have set (tone 1 or tone
2).
Press the STOP button on the
RingFlash unit to stop the Doorbell
tone. The red light on the Doorbell
button will remain on for 1 minute and
then turn off.
Compatibility with other local devices
(RingFlash 200 only)
When using the RingFlash 200 and
Doorbell there may occasionally be
a compatibility problem with other
local devices. You can change the
code undereath the RingFlash unit
and inside the doorbell to solve this
problem.
Service Hotline UK Tel. 0844 800 6503, cost via UK landline at time of going to print: 6p connection charge and 5p/min. thereafter,
different charges may apply if calling from a mobile phone. Hotline hours are Monday to Friday, 9am to 5pm, excluding public and national holidays
Using your RingFlash 100/200
Underneath the RingFlash unit you
will fi nd 8 little switches underneath a
cover. You can change the setting of
these switches to overcome any local
compatibility issues.
When you have changed the setting of
the 8 switches on the RingFlash unit
you will need to change the 8 switches
inside the Doorbell to match.
Unscrew the Doorbell from outside
the Front Door. Remove the 4 screws
from the back of the Doorbell. Inside
you will see 8 little switches, change
the setting of these switches to match
those on the RingFlash unit.
ON
1 2 3 4 5 6 7 8
DP
GB
29