Amplicom RingFlash 100 Mode D'emploi page 25

Connecting the doorbell unit
(RingFlash 200 only)
Remove the 4 screws from the back
of the Doorbell.
The Doorbell has a default setting
of Bell 1, if you wish to change this
to Bell 2, please move the switches
inside the Doorbell to the positions
indicated below.
The stop indicator button on
ON
the RingFlash unit will be red
when the Doorbell is pressed.
1 2
Bell 1
The stop indicator button on
ON
the RingFlash unit will be
green when the Doorbell is
1 2
pressed.
Bell 2
Insert the 12 Volt battery supplied,
taking note to position the battery
the correct way around. Replace the
back cover, position and tighten the 4
screws.
Service Hotline UK Tel. 0844 800 6503, cost via UK landline at time of going to print: 6p connection charge and 5p/min. thereafter,
different charges may apply if calling from a mobile phone. Hotline hours are Monday to Friday, 9am to 5pm, excluding public and national holidays
ON DP
1 2 3 4 5 6 7 8
ON
1 2
You only need to change the Bell setting
if you have more than one Doorbell
connected to your RingFlash unit. The
two options are provided so that you will
know from the colour of the light on the
STOP button which Doorbell has been
pressed and which Door to answer.
Unclip the front cover of the Doorbell
by placing a small coin into the slot at
either end of the doorbell and twisting.
Using the 4 screws and wall plugs
provided, attach the Doorbell outside
your front door.
Starting Up
GB
25