Pen Input Problems; Usb Device Problems - Fujitsu STYLISTIC Q550 Mode D'emploi

Problem

Pen Input Problems

Cursor is not tracking the
pen.
Tablet is not responding to
the pen
Memory Problems
Your System screen in the
Control Panel does not
show the correct amount
of installed memory.

USB Device Problems

Your system doesn't rec-
ognize a USB device you
installed, or the device
doesn't work properly.
Possible Cause
Display needs to be cali-
brated
System may have crashed.
You have a memory
failure.
The device is not properly
installed.
The device may have been
installed while an application
was running, so your system
is not aware of its installation.
Your device may not have the
correct software driver active.
57 - Troubleshooting
Possible Solutions
See "Calibrating the Display" on page 25. for more informa-
tion.
If the Tablet PC does not respond to the pen, connect an
external keyboard to the system to see if it responds to key-
board commands. If the system doesn't respond to a key-
board, the application or system may have crashed, and it
may be necessary to reboot the system. If the system
responds to a keyboard but not to a pen, contact your local
help desk or reseller, or call Fujitsu Service and Support at 1-
800-8Fujitsu (1-800-838-5487) for further assistance.
Check for Power On Self Test (POST) messages. See
"Power On Self Test Messages" on page 62.
Remove and re-install the device.
Close the application and restart your Tablet PC.
See your software documentation and activate the correct
driver.