Brequet 7027 Mode D'emploi page 5

7027
"T "
WATCH
RADITION
MANUALLY WOUND
The crown has two positions:
1. Neutral position
(manual winding)
2. Time-setting position
, -
OFF CENTRED HOUR CHAPTER RING
, -
WATER RESISTANT TO
Starting the watch
Crown in position 1. This position
allows you to wind the movement. To
start the watch, wind it fully (when
the hand of the power-reserve seg-
ment A is at its maximum) by turning
the crown upwards (
tance is felt. ON NO ACCOUNT FORCE
THE CROWN. When the resistance is
felt at the end of winding, it is impor-
tant to turn the crown downwards
( ) (at least
M M
release the crown wheel. Thereafter,
wind the watch daily.
30
M
Setting the time
Pull the crown out to position 2. Then
turn the crown downwards (
move the hands forwards to the
desired time. For accurate time-set-
ting, ensure that the last operation was
) until resis- done in a clockwise direction. Then
L L
push the crown back to position 1.
After this operation, rotate the crown
downwards (
freely.
1 / turn) in order to
4
, -
POWER RESERVE
) to make sure it turns
M M
,
) to
M M