Replacing The Remote Batteries; Water Drainage; Important - Dandy DPA140HEAUWDB Manuel Du Propriétaire

OPERATING INSTRUCTIONS

REPLACING THE REMOTE BATTERIES

The remote control will arrive with a CR2025 coin
battery pre-installed. It may be necessary to remove
a clear, plastic insulating strip before fi rst use of the
remote control.
Follow the steps below to replace the battery.
1. Use a screwdriver to remove the screw that
secures the battery cover.
2. Push the battery cover hook to the right to
release it from the remote control. Pull the
battery cover out.
1
2
Notes:
• The air conditioner will not respond if curtains,
doors or other materials block the signal from
the remote control to the appliance.
• If the infrared signal receiver on the indoor unit
is exposed to direct sunlight, the air conditioner
may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
• Do not allow the remote control to get wet.
• Do not expose the remote control to direct
sunlight or heat.
• Do not leave the battery in the remote control
if it is not going to be used for more than 2
months.

IMPORTANT

Do not dispose of
batteries as unsorted
municipal waste. Refer
to local laws for proper
disposal of batteries.

WATER DRAINAGE

When the internal drain pan becomes full the
appliance will beep 8 times and the digital display
will show error code P1. The air conditioning or
dehumidifying action will stop but the fan may
continue to operate.
Follow the steps below to drain the appliance.
1. Turn the appliance off and unplug it from the
power source.
2. Carefully move the appliance to a location
where the water can be drained.
3. Remove the drain plug and allow the water to
completely drain.
4. Replace the bottom drain plug, pressing fi rmly to
ensure a tight fi t and no leaks.
5. The P1 error symbol will disappear and the
appliance will resume regular function once
power is restored.
9