Battery Installation; Headset Connection - Topcom SWEETHEART Manuel D'utilisateur

TOPCOM Sweetheart
3

Battery installation

• Open the battery compartment by pulling the cover away.
• Insert 1 x 9V (6LR61) non-rechargeable battery following the polarity as indicated
in the battery compartment.
• Re-install the battery cover.
When the LED is red, the batteries needs to be replaced.
Do not short-circuit & dispose of batteries in fire.
Remove the battery if this device is not going to be used for a long
period.
4

Headset connection

Connect the earphone to the earphone jack of the probe as indicated.
For your safety, only use the supplied earphone.
5 Connection to an audio amplifier or recorder
Connect one end of the supplied audio cable to the earphone jack of probe and the other
end to the line-in off your amplifier or recording device.
Change the audio level of your doppler to avoid distortion.
All audio will be transferred to your audio system.
4
+