Residual Risks; Warranty Conditions - easy!maxx TMK-005A1 Mode D'emploi

❐ Warning: If the saw blade catches during use or is improperly aligned, this may result in
kickback. This in turn may cause the saw blade to move out of the saw gap, lift up the saw
and the force of the motor may then cause it to kick back towards the operator. To prevent
kickback, the following precautions should be taken:
– Hold the saw fi rmly and position your arms so that you are able to absorb kickback forces.
– Always position your body to the side of the saw blade and never in line with it.
– If the saw blade jams or if you interrupt work, turn off the saw and hold it securely in the
workpiece until the saw blade has come to a stop. Never attempt to remove the saw from
the workpiece or pull it back when the saw blade is moving. Determine and rectify the
cause of the jam.
– If you want to restart a saw in a workpiece, centre the saw blade in the saw gap and ensure
that the saw teeth are not stuck in the workpiece.
– Support large planks on both sides: Both in the vicinity of the sawing area and the edges.
– Before sawing, tighten the saw depth and angle adjustment.
❐ Store the device out of the reach of children and pets.

Residual risks

❐ The following residual risks may exist even if the device is used properly and in the event of
compliance with all safety notes in these instructions:
– Contact with the saw blade in the unshielded area (cut injuries)
– Contact with the running saw blade during operation (cut injuries)
– Unforeseeable, sudden movement of the workpiece (kickback risk)
– Separation / projection of parts from the workpiece (risk of injury if insuffi cient protective
clothing is worn)
For this reason, always handle the device in an attentive and careful manner!

Warranty conditions

Defects arising due to improper handling, damage or attempts to repair the appliance are
excluded from the warranty. This also applies to normal wear and tear.
22