Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9. ASSEMBLY INSTRUCTIONS
9.1 Remove all cord wraps and uncoil the cables prior to using the unit.
10. MOUNTING INSTRUCTIONS
To permanently mount the unit, use the
following instructions:
10.1 Slide all 4 brackets (Item 1) into the track
on the back, from the right side, as shown
above. Make sure the set screws (Item 2)
are unscrewed enough so they do not
scratch the surface of the housing.
10.2 Measure what you are mounting the
unit to before deciding where to locate
the brackets (add an additional ¼ to ½
inch). Use the ruler on the label (Item
3) to mount the brackets (Item 1) in the
correct position (position each bracket an
equal distance from the center of the unit).
4
2
Note that the inches shown are for both
bracket dimensions combined (meaning
the dimensions are doubled), this is for
easier reference. Make sure the ¼-28 set
screws (Item 4) are unscrewed enough
so the pointed end is almost flush with the
bracket. Mount the brackets (Item 1) by
tightening all 8 set screws (Item 2) to 14
in/lb (1.6 n/m) of torque.
10.3 Lift the unit by its handle and set it against
your mounting location, tighten the set
screws (Item 4) to 66 in/lb (7.5 n/m) of
torque to secure the brackets (Item 1),
starting with the top two brackets first.
• 5 •
1
3
Publicité
Table des Matières
