Solid-State Thermostat Descriptions; Front Panel Commands; Key Function - Maxx Cold MXM1 Manuel D'utilisation, D'installation Et D'entretien

SOLID-STATE THERMOSTAT DESCRIPTIONS

1. FRONT PANEL COMMANDS

1.1 KEY FUNCTION

To display target set point; in programming mode it selects a parameter or
confirms an operation.
To start a manual defrost
To see the last temperature alarm; in programming mode it browses the
parameter codes or increases the display value
To see the last temperature alarm; in programming mode it browses the
parameter codes or decreases the display value
KEY COMBINATION
To lock & unlock the keyboard
To enter programming mode
To return to the room temperature display
1.2 LEDS
LED MODE
Flashing
Flashing
Flashing
5
FUNCTION
ON Compressor Enabled
Programming Phase
Anti-short cycle delay enabled
ON Defrost Enabled
Programming Phase
Drip time in progress
ON Fans Enabled
Fans delay after defrost in progress
ON A temperature alarm happens