Troubleshooting; Corrective Action; Repairs, Spare Parts - Metabo XciteRC Quadcopter Mode D'emploi

Troubleshooting · Repairs

Troubleshooting

Problem Possible Cause
Rotor don't move ON/OFF switch is OFF
Weak Quadrocopter battery
Transmitter - model not bound
Rotor stops sud- Weak Quadrocopter battery
denly, Quadrocop- Weak transmitter battery
ter chrashes
The Quadrocopter Gyro initialisation failure
does not react to
the remote control. Quadcopter not bound to the trans-
Loss of control. mitter
Gyro calibration failure after a crash
The Quadrocopter Gyro calibration failure after a crash
flies uncontrollably

Repairs, Spare Parts

Normal wear and defective parts that result from an accident, are excluded from the guarantee. These in-
clude in particular:
For car models: bald tires, worn parts and drive gears, or bent / broken suspension, chassis or bodywork
For ship models: damaged or broken propellers, torn superstructure
For airplanes: damage due to improper transportation or crash
I If you find a part that is defective in material or workmanship right after opening the package, return - before
you used it – to your dealer or directly to us and we will send you a replacement.
For the Metabo Quadcopter some parts are available as spares. If a part is defective or worn, you can identify
it with the help of the online spare parts list.
In case of problems or questions, please contact your dealer or:
XciteRC Modellbau GmbH & Co. KG - Service, Autenbachstrasse 12, D-73035 Göppingen, Phone +49 7161
40 799 50
Email: service@xciterc.de
Spare parts for the Metabo Quadcopter you may order in your local hobby shop or online at http://www.
XciteRC.com/
Metabo Quadcopter

Corrective Action

Switch ON Quadrocopter
Re-charge battery
Rebind: first switch on the model, then the
transmitter
Re-charge battery
Change transmitter batteries
Place the model on a flat surface when
switching on
Re-bind: switch on the quadcopter first,
then the transmitter
Re-calibrate the gyro, see section: Get-
ting Started, gyro calibration
Re-calibrate the gyro, see section Getting
Started, gyro calibration
EN
23