Getting Started - Metabo XciteRC Quadcopter Mode D'emploi

Getting started · Gyro calibration
• Connect the USB cable to a PC or appropriate power supply. The red LED lits.
• Connect the Quadrocopter battery with the charger.
• WARNING: The Quadrocopter battery is polarized. Check the side channels. Do not use force - fi re
or explosion hazard!
• The red LED goes out to indicate charging. Charging time is about 50 minutes. If the battery is fully char-
ged, the red LED lights up again.
• Unplug the battery and the USB cable.
The fl ight time of the Quadrocopter is about 6-8 minutes.

Getting started

Before you begin please check:
• WARNING: Only start with a suffi ciently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the fl ying qualities.
• Place into the battery compartment on the rear (1) and connect it to the quadrocopter (2).
• WARNING: The battery connector is polarized. Check the side channels. Do not use force - fi re or
explosion hazard!
- LED flashing fast: automatic
detection
- LED flashing slowly: ready to
bind
- LED on: Binding completed
• Place the Quadrocopter on a fl at surface in the starting position and switch it on (1). The LEDs fi rst fl a-
shes quickly, then after a few seconds slow. Now switch the transmitter on. Move the left throttle lever all
the way up and then back in the lowest position (2). This safety circuit prevents the rotor may start after
turning ON the Quadrocopter
• The model is ready to fl y as soon as a short beep is heard. The POWER LED of the transmitter and the
Quadrocopters LED lights up solid.
• Note: when the model is not used for about 30 seconds, it automatically switches back to the bind
mode, the LEDs starts to fl ash. To fl y, the throttle must once again moved all the way up and then back
in the lowest position
• GYRO CALIBRATION: before the fi rst fl ight the gyro must be calibrated. Move both control levers
downwards to the left and hold until all LEDs fl ash briefl y. This is also necessary if the model fl ies badly
e.g. after a crash.
Metabo Quadcopter
1
1. First move up
1 2
2. Move down immediately
2
2
EN
19