Reversible Door - Eico W155 Mode D'emploi

Reversible door

The door can be changed from right-hinged to left-hinged and vice versa as follows:
1. Lay the appliance on its back and loosen
the upper hinge.
4. Carefully remove the covers on the
side of the plinth using a flat-headed
screwdriver.
7. When the lock pin has been loosened
completely, pull it up together with the
lock cylinder and refit on opposite side.
10. After reversing the door, it is important to check that the sealing strip provides a tight seal all the way round. If it does not, carefully heat
the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet. Be
careful not to heat the strip so much that it melts!
OBS: You will need to remove the magnet on the underside of the door by unscrewing the two screws, pulling the magnet away from the door
and mount it at the other end of the door. If there is a logo badge on the door you will have to remove it and possibly fit it at the other end of
the door.
Remove the top and bottom bushes on the door frame (the bushes are the black, round plastic pieces which fit into the top and bottom hinges)
and reverse them so that the bush which was at the top is now at the bottom and vice versa.
2. Remove the upper hinge.
5. Pull up the hinge pin...
...and fit it on the opposite side.
8. Click the covers into place on the plinth
sides on the opposite side.
9
3. Rotate the glass door through 180° (on
FZ 295 W, pull the handle to loosen it
on the inside from beneath the sealing
strip).
6. Unscrew the lock pin using a flat-headed
screwdriver.
9. Fit the door onto the bottom pin, fit the
top hinge and tighten securely.
GB
GB