Homeright POWER-FLO PRO 2800 1/2 HP Mode D'emploi page 8

POWER-FLO PRO 2800 SPRAY GUN ASSEMBLY
®
When assembling the spray gun, it is important to correctly insert the Saddle Seat-Washer assembly.
The Saddle Seat has a curved section designed to align with the Spray Tip when assembled.
The Saddle Seat and the plastic washer come pre-assembled.
Spray
Guard
1
Insert Saddle Seat first into
Spray Guard, as shown, with
the curved part of the Saddle
aligned with the Spray Tip hole.
Use the plastic pointer on the
Spray tip to fully seat, if needed.
Actual product may differ from image shown.
SPRAY GUN ASSEMBLY
Spray Tip
Saddle Seat-Plastic
Washer Assembly
2
Insert Spray Tip into Spray
Guard. The curved part of the
Saddle Seat should fit with the
Spray Tip.
Keep the Spray Guard pointing
down to prevent the Saddle
Seat-Washer assembly from
falling out.
800879 POWER-FLO PRO 2800
®
3
Keeping the Spray Guard and
Gun pointing down to prevent
the Saddle Seat-Washer
assembly from falling out,
screw the Guard to the Gun
and hand tighten.
Spray
Gun
ENGLISH