Cleaning And Maintenance - Kampa Cross AIR TG Notice D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Using the awning tent

CAUTION! Risk of injury and material damage

Never open the zipper on the protective sleeve while an air

pole is inflated. This will result in the air pole bursting.

Before first use

Familiarize yourself with the product by carrying out a test set up before

the product is used for the first time. Check if the scope of delivery is

complete.

Choosing a site

Choose a flat site that is protected from wind:

1. If necessary, use a windbreak.

2. Choose a shaded site to avoid UV degradation of the fabric.

3. Avoid pitching under trees as falling branches, resin, etc. can damage

the product.

4. Clear the site of sharp stones and debris to avoid damaging the

groundsheet.

5. Set up the product with the doors facing away from the wind.

Setting up the awning tent

CAUTION! Risk of injury and material damage

•

Do not use any type of compressor designed to inflate

car tires.

•

Only inflate the air poles into the green zone of the

pressure gauge of the supplied hand pump

(7 – 8 psi/0.48 – 0.55 bar).

NOTICE! Material damage

•

Do not open or close the zippers by force.

•

If a wind-out awning is used to attach the awning tent,

support the wind-out awning while working to avoid

putting too much stress on it. After attaching the awning

tent, rewind the wind-out awning fully back into its hous-

ing.

NOTE

•

The awning tent comes with heavy duty pegs. These will

be suitable for many sites but for some types of ground

special pegs will be needed. Ask your dealer.

•

Drive the pegs at a 45° angle away from the awning tent

into the ground.

•

Peg each guy line in-line with the seam it starts from.

Keep the following tips in mind while setting up the awning tent:

•

The figures provide a general overview of the set-up. The actual set-up

will vary slightly based on the model of awning tent.

•

Get help. The set-up is easier with more people.

•

After standing the awning tent upright, check the corner pegs and

re-peg if necessary. The groundsheet on the inside should be taut and

in a rectangular shape.

•

Peg the guy lines so that the awning tent is under tension without dis-

torting the shape.

•

If available, attach the storm straps.

•

Check the guy lines from time to time to ensure adequate tension, if

necessary use the runners to adjust.

Set up the awning tent as follows:

1. To protect the awning tent from dirt and damage, lay down a ground-

sheet or footprint before unpacking.

2. Unpack the awning tent.

3. Separate and identify the different components.

4. Proceed as shown to set up the awning tent (fig. 2, page 3 to

fig. i, page 7).

Dismantling the awning tent

NOTICE! Damage hazard

Do not use force when dismantling the awning tent. Other-

wise you might damage any material.

1. Remove any dirt on the outside.

2. Close all window blinds or remove curtains.

3. Close all doors and openings.

4. If installed, push the canopy pole out of the sleeve, do not pull.

5. Remove all lines and straps.

6. Remove all pegs between the corner pegs.

7. Open the valves on each pole.

8. Wait until most of the air has been expelled.

9. Remove the four corner pegs.

10. Fold/roll the awning tent towards the valves to expel more air.

11. When deflated, roll the awning tent to fit into the carry bag.

12. Ensure that all parts are clean before packing them into the carry bag.

13. If the awning tent is wet or damp, dry fully as soon as possible.