Accessories; Ec Declaration Of Conformity - Woodstar wl 05 Traduction Du Manuel D'utilisation Original

24
stalled immediately upon completion of any repair or
maintenance work.
• Clean and lightly oil the spindle thread of the tool
holder when changing tools.
• When possible, the tail stock sleeve should be removed
by unscrewing it, cleaned and then sprayed with a dry
lubricant. Grease the threaded spindle.
• Check the eccentric clamp of the tailstock as well as
the tool holder and adjust if necessary. In addition,
tighten the hex nut under the bracket.
• Check the drive belt and replace when necessary.

Accessories

Article
Screw chuck
Socket chuck Ø 30 mm
Socket chuck Ø 40 mm
Socket chuck Ø 60 mm
Driver plate Ø 80 mm
Three-jaw chuck Ø 100 mm
Four-jaw chuck Ø 125 mm
Drill chuck 3 – 16 mm cone mandrel MK-2 7400 7700

EC Declaration of Conformity

We herewith declare, Woodster GmbH, Günzburger Str. 69, D-89335
Ichenhausen that the machine described below due to its con struc-
tion and design and in the version delivered by us complies with the
relevant provisions of the following EC Directives.
In case of a modification of the machine this declara tion ceases to
be valid.
Machine description:
Wood Turner Lathe
Machine type:
wl 05, Art. No. 390 2301 908, 390 2301 911
Relevant EC directives:
EC machine directive 2006/42/EG,
EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Applied harmonized European standards
EN 12100-1, EN 12100-2, EN 13857, EN 55014, EN 50082-1, EN
60555-2, EN 60 204-1
Notified body within the meaning of Annex VII
TÜV Rheinland, product Safety Gmbh, 51101 Köln
Engaged for:
EG-Baumusterbescheinigung 5002 1766
Place, date:
Ichenhausen, 29.06.2009
Signature:
On behalf of Thomas honigmann (Managing director)
Art. No.
7400 7200
7400 8600
7400 7300
7400 8700
7400 8800
7400 8900
7400 7400