- Never connected to an extension cord unless it´s approved for at least 10 A.
- Do not subject the unit to detrimental environmental influences (strong sunlight etc).
- Never allow unsupervised children, or incapable persons, to use it.
- Never immerse an electrical device in water.
- Check regularly, but most definitely before every use, the mains cable and mains plug for damage.
- If any damage is visible, then further use of the unit must not be made.
- If any damage and/or reduced functioning occurs, switch off and do not manipulate the unit.
- If, in such as event, a repair is necessary, contact an authorised by the manufacturer customer
service point.
- Do not pull on the cable or unit in order to separate the plug from the socket.
- Turn the unit off and unplug the power cord when the appliance is not in use, before cleaning
and when changing the location of the appliance.
- Do not use the appliance where it can fall or push into the water. Never reach for the appliance
that has fallen into the water. Switch off the mains fuse immediately and unplug the mains plug.
- The appliance is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given super-
vision or instruction concerning use of the appliance in a safe way and understand the hazards
involved.
- Disconnect the appliance from the mains before performing any maintenance work, by plugging
the plug or disconnecting the electrical system.
- Always take note of the general safety rules when using electrical equipment.
Maintenance/cleaning notes
- Before carrying out any cleaning or maintenance work, remove the plug or switch off the electri-
cal equipment!
- Clean the surface of the housing and the guard with a dry cleaning cloth and a damp brush.
- Do not use petrol or any similar light flammable cleaning material.
- Cleaning and user maintenance shall not be made by children without supervision.
Storage
- If the fan is not to be used for some time, then store it in a dry room.
- In addition, you could put a cover on your unit to protect it from dust or dirt deposits.
Disposal
- Remove mains plug.
- Cut through the mains cable at the plug.
- Dispose of the unit in a proper manner.
Help with faults
Problem
The heater does
not work.
If the above information does not fix the problem, unplug the heater by removing the plug
from the wall socket.
In the case of a damage or breakdown, please leave the heater with a qualified electrician to
fix the problem.
If the power cord on the unit is damaged it may only be replaced by a repair facility authorised
by the manufacturer. Replacement of the power cord requires special tools.
Attention: Any repairs including replacing the halogen heating lamp should only be car-
ried out by a qualified electrician or by a recommended service center!
Suggestions for rectification
1-
Check main and ancillary fuses. It should be an non-fast acting fuse
dimensioned for the maximum power of your heater.
2-
Check heater for correct connection to the power socket.
3-
Check the both switch settings (Standby and On/Off) at the heater.
EN
13