Linea Domo DO7302C Mode D'emploi page 21

sales service of the manufacturer, to make that original
parts will be used.
• When you decide to never use the convector again, we
recommend to cut off the power cord completely, after
you have removed the plug from the socket.
• Installation of the convector must be done according to the
specifications of the manufacturer. A wrong installation
can lead to accidents with people, animals or damage to
objects. The manufacturer cannot be held responsible for
this.
• The convector must always be used upright.
• The inlet grill of the convector must always be left free.
• Make sure that the current is the same as mentioned on
the rating label. When in doubt, let it be checked by an
electrician.
• Don't let the convector operate when it is not necessary.
Remove the plug from the socket when you don't need the
convector.
• Don't cover up the air inlet and air outlet grill.
• Don't place the convector against a socket.
• The power cord of this convector cannot be replaced by
the consumer. For the replacement of the cord you can
only make an appeal on the after sales service of the
manufacturer.
• Prevent contact with the warm convector and make sure
the cord isn't placed in the hot air flow.
OPERATION INSTRUCTIONS
By putting the top rotating knob on 1,2 or 3 dots, you determine how much warmth
the convector needs to give.
For model DO-7303C : when you also want to use the fan, you need to place the red
button on the front of the unit on "1". This function can also be used to ventilate cold
air.
21
DO7302C-DO7303C