Input Selection; Basic Operations; Operation With The Buttons On The Tv; Operation With The Remote Control - Saba CLS16V4 Mode D'emploi

Input Selection

Once you have connected external systems to your
TV, you can switch to different input sources.
• Press "AV/SOURCE" button on your remote control
for directly changing sources.
or
• Select "Source" option from the main menu
by using " " or " " button. Use then " " or
" " button to highlight an input and press " " button
to select.
Note : You can mark desired source options by pressing
the OK button. Therefore, when
is pressed, only the marked source options will be available
(except for the TV source).
Note : YPbPr mode can be use only when you connect a
device that has a YPbPr output through the PC input with
YPbPr to PC cable (YPbPr cable is not supplied).

Basic Operations

You can operate your TV using both the remote
control and onset buttons.

Operation with the Buttons on the TV

Main menu OSD cannot be displayed via control
buttons. "+/-" buttons will function as volume up/down
as default. Even if you set other functions for these
buttons, "+/-" buttons will perform as default after a
short while.
Volume Setting
• Press "P/V/AV " button once and then use "+/-" buttons
to increase or decrease volume, so a volume level
scale (slider) will be displayed on the screen.
Programme Selection
• Press "+/-" to select the next or previous programme.
AV Mode
• Hold the "P/V/AV " button, source OSD will be
displayed.

Operation with the Remote Control

• The remote control of your TV is designed to control
all the functions of the model you selected. The
functions will be described in accordance with the
menu system of your TV.
02_[GB]_MB45_1055UK_PANEUIDTV_BRONZE11_16857_10065235_50156815.indd 39
• Functions of the menu system are described in the
Volume Setting
• Press "
Programme Selection (Previous or Next
Programme)
• Press " P/Ch - " button to select the previous
• Press " P/Ch + " button to select the next programme.
"AV/SOURCE"
button Programme Selection (Direct Access)
• Press numeric buttons on the remote control to select
• Press directly the programme number to reselect
When the TV is turned on for the  rst time, the menu
for the language selection appears on the screen. The
message "Welcome please select your language!"
is displayed in all language options sequentially in
the OSD.
By pressing the " " or " " buttons highlight the
language you want to set and press OK button. After
then, "First time installation" OSD will appear on the
screen. By pressing " " or " " buttons, select the
country you want to set and press OK button (* for
EU countries).
Note: Country selection OSD will not be available for UK.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the "Yes" or "No" option, highlight the item
The IDTV will automatically tune to the UHF or VHF(*)
(* for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying
the names of channels found. This process will take
about a few minutes.
English - 39 -
following sections.
" button to increase the volume. Press "
" button to decrease the volume. A volume level
scale (slider) will be displayed on the screen.
programme.
programmes between 0 and 9. The TV will switch
to the selected programme. To select programmes
between 10-500 (for IDTV) or 10-199 (for analogue),
press the numeric buttons consecutively
single digit programmes

Initial Settings

by using " " or " " buttons and press the "OK"
button.
05.10.2009 09:19:08