Jump Starting; Sequence Of Operations - Deca Fast 7k Manuel D'instruction

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
cables, if it has received dents, if it has been
dropped or if it has been damaged.
„ Do not use the appliance if during use,
charge or conservation the battery smells,
heats up, or deforms or has acid leaks.
„ Do not disassemble the appliance but take
it to a qualified service centre.
„ Clean the appliance with a dry cloth. Do not
use solvents or other detergent aggressive
substances.
„ Store the appliance at ambient temperature
(20 - 25 °), keep it away from direct sunlight
and away from heat sources.
Description of the starter
This appliance is a portable multifunction
starter equipped with a lithium battery.
It can be used as an emergency starter for
motor vehicles with 12-volt electrical system;
it can recharge / supply 5V electronic
devices.
It is equipped with a LED light with the
function of continuous, intermittent, SOS
light.
Controls, reports and accessories Fig.1
A) Multifunction Starter
B) Cable with clamps for jump starting
C) Multi USB Cable
D) USB / MICRO USB cable
E) Cigarette lighter 12/24V power supply
1) Terminals for start clamps 12V
2) Output USB port for power supply 5V
2,1A,
3) Input MICRO USB port for charging 5V,
1A
4) Key ON / OFF (output USB)
5) Key for the verification of the charge
status, USB output, LED light
6) LED charge status
7) LED light

Jump starting

Use the appliance only as an
emergency starter to support the
vehicle battery. Do not use it alone
instead of the battery.
„ Avoid the formation of flames or sparks. To
avoid sparks, make sure that the clamps
cannot disengage from the poles of the
950691-00 14/06/19
battery during charging.
„ Stay away from moving parts such as fans,
transmission belts and pulleys.
„ Stay away from hot parts, such as engine
and cooling system to avoid burns.
„ Do not short circuit the terminals for the
emergency start cable because they are
always under tension.
„ Avoids that the red and black clamps come
into contact. Accidental short circuits of the
terminals caused by an electrical conductor
object for example a tool, a jewel, etc. could
generate enough heat to cause serious
burns, electric arc or cause incandescent
metal splashes.
„ Do not reverse the polarity of the positive
"+" negative and "-" terminals

Sequence of operations

Starter battery must be fully charged
(4 led lit).
C a r e f u l l y f o l l o w t h e s t a r t i n g
procedure, failure to comply may
affect the life of the appliance.
1 Make sure that the vehicle ignition key is
in the OFF position: all services turned off.
2 Insert the cable with the clamps (B) into
the socket (1).
3 Connect red charging clamp to positive
(+) battery terminal and black charging
clamp (-) to negative battery terminal.
If the battery is installed on a motor
vehicle, first connect the clamp to the
battery terminal that is not connected to
the bodywork. Afterwards, connect the
second clamp to the bodywork at a point
far from both the battery and the petrol
pipes.
4 Rotate the ignition key for up to 3 seconds.
If the vehicle did not start wait at
least 15 seconds before trying again.
If the vehicle did not start even the
second time wait at least 2 minutes.
¾After starting leave the engine running and
disconnect the starter:
¾Disconnect in the order the black clamp "-"
and then the red clamp "+".
¾Disconnect the cable with the clamps from
the starter and put everything into its box.
6

Publicité

Table des Matières
loading

Table des Matières