Fagor CA-90CI Manuel D'utilisation page 9

appliance come into contact or near hot
surfaces (kitchen gas or electric hobs or
ovens).
• Do not use detergents or abrasive
sponges to clean the appliance.
• Do not touch the hot surfaces. Use the
handles.
• Do not let the cable come into contact
with the hot parts of the appliance.
• Do not cover the cord, for example with
a rug or similar. Place the cord far away
from any walk way or anywhere where
people might trip over it.
• In order to ensure the air grille does not
become blocked, keep the fan at least
20 cm away from the wall.
• Do not place the fan beneath curtains
or similar.
• Do not introduce any objects into the
grille.
• Do not leave the appliance next to any
focus of heat or on hot surfaces.
• Do not direct the flow of air directly
towards babies or ill persons.
• This appliance should not be used
by physically, sensorially or mentally
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance
by a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
• For greater protection, we recommend
installing a residual current device
(RCD) with an operational residual
current not exceeding 30 mA. Ask your
installer for advice.
4. ASSEMBLY
Fit the two parts of the base (3) together as
shown in Fig. 2. Thread the cable through
the central hole in the base. Align the screw
holes on the base with those of the fan.
Then insert the screws and tighten them
(Fig. 3).
Position the cable in the groove on the
base (Fig. 4).
5. OPERATION
Before operating the fan, place it on a flat,
stable surface.
The fan may be controlled using the
buttons on the control panel or the remote
control as it has the same functions.
Switching the fan on and off: Press
the On/Off button (5) on the control
panel or on the remote control, to
start up the fan. Press this button
again to switch it off.
Speed setting: Press the speed
setting button (6) to select the air flow
rate. When you switch on the fan the
set speed will be "low". Press the
button once to set a "medium speed,
twice for "high" speed, and three
times to return to "low" speed.
According to the speed you have selected,
the light indicator corresponding to this
speed will light up.
Ventilation type:
When you switch on the fan, "normal"
mode (a).
The fan will run continuously at the speed
selected. Press the
"natural" mode (b) and twice to set "night"
mode (c). If you wish to return to "normal"
mode, press the ventilation type setting
button a third time (7). The light indicator
for each time of ventilation will light up.
Oscillation: Press the oscillation
button (8) to make the fan oscillate
horizontally and thereby cool larger
spaces more efficiently. If you wish to
stop oscillation, press the same button
again.
Timer: This fan has a timer with a
range of 1 - 12 hours (g). You may
programme the fan to switch off
automatically after the functioning time
set.
Press the timer button (9) to set the
time. Each time you press the button
8
button once to set