Ex-Tech XY2WCE1A250 Mode D'emploi page 14

 Position the cam by rotating it
 Reposition the index by tensioning the
cable according to the cam selected
 Set the device
 Trip the switch, reset and repeat the
operation
 Check the position of the index and
reposition, if necessary
 Replace the cover
 Device's electrical connection on the
screw clamp terminals: min. 1 x 0.5 mm²,
max. 1 x 2.5 mm² or 2 x 1.5 mm²
 The viewing port allows you to check at
any time that cable tension is correct
Particular case :
Where the device is installed when the ambient temperature is extreme
(a) OBJECTIVE: this setting makes it possible to anticipate a
drop in temperature during operation
(b) OBJECTIVE: this setting makes it possible to anticipate a rise in
temperature during operation (the diagrams show the device with an
RH cable anchor point. Reverse the pushbutton's position for
devices with an LH cable anchor point).
XY2004A12-07 01/12/2016
Operating instructions
Trip wire switch - XY2W series
ENG
14/16