Backlight - ChimneyFree 35HF500GRA-BLK Manuel D'instruction

HEATER BUTTON
Wall hanging fireplace houses two heaters, and there are four levels you can cycle through, including the
OFF setting.
Press once: Left heater turns on (indicator lights illuminated ●○).
Press twice: Right heater turns on (indicator lights illuminated ○● ).
Press three times: Both heaters turn on (indicator lights illuminated ●●).
Press fourth time: Turns heaters off (indicator lights illuminated ○○).
NOTE: Holding the HEATER button on the control panel for 10 second will disable the heater function.
To re-enable the heater press and the hold the HEATER button for 10 seconds.
REMOTE CONTROL FUNCTIONS
Remote control features work seamlessly with control panel functions.
NOTE: The main power switch must be switched ON in order for the remote control to function.
- POWER
The power button will put the fireplace in a standby mode. This will turn off all functions at once but
will hold the settings in memory except the heater function.
- FLAME
The fireplace has four flame effects; by pressing the FLAME button the unit will cycle through
each effect.

- BACKLIGHT

The fireplace has five backlight effects; by pressing the backlight button the unit will cycle through
each effect, including OFF setting.
- SPEED
Press SPEED button, the flame speed will be changed. There are 3 speed levels.
- HEATER Wall hanging fireplace houses two heaters, and there are four levels you can cycle
through, including the OFF setting.
Press once: Left heater turns on (indicator lights illuminated ●○).
Press twice: Right heater turns on (indicator lights illuminated ○● ).
Press three times: Both heaters turn on (indicator lights illuminated ●●).
Press fourth time: Turns heater off (indicator lights illuminated ○○).
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Modifications not approved by the party responsible for compliance could void user's authority to operate
the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
Note: please operate remote transmitter at a slow measured pace. Press the remote control buttons with
an even motion and gentle pressure. Repeatedly pressing buttons in rapid succession may cause the
transmitter to Malfunction.
10