Publicité
Les langues disponibles
Les langues disponibles
Attention!
Before you start working, check whether the accessory has the exact
position.
Let the machine start running in a safe position for a short time. In case
the machine does not run easily, immediately stop working.
Dust Extraction
Dust which appears during work is harmful to health. For this reason, use an
industrial vacuum cleaner while sanding.
The appropriate Wet/Dry Vacuum Cleaner DSS 25 M is available as
accessory. Directly connect it to the nozzles which are meant for it on the dust
hood.
Connect the lead cable of the dry-wall sander with the industrial vacuum
cleaner and then connect the extraction hose with dust hood of the sander.
Lead the extraction hose and the cable to the back away from the machine.
Activate the switch-on automatic on the vacuum cleaner.
Switch the machine on and put it carefully on the surface you want to work on.
Hold the machine with both hands and move it in a linear or rotary way.
For sanding works directly on wall edges you can remove a segment from the
protection hood. This allows working even on spots which are usually hard to
reach.
Attention!
!
Do not touch rotating parts!
Care and Maintenance
Before the beginning of the maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist. Due to its design, the machine needs a minimum of care and
maintenance. However, the following points have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the machine.
In case of failure, a repair has to be carried out by an authorised service
workshop.
Our after-sales service responds to your questions concerning maintenance
and repair of your product as well as spare parts.
Handling
16
Publicité
