Climadiff HUM50 Notice D'utilisation page 25

b) Timer function
1. Press the "S" key to switch to the time setting mode while the display flashes in 0.5s, use the "+" and
"-" keys to set the time. Values range from 1 to 12.
2. When the unit is in the time setting mode, this does not change the old setting and does not restart a
new programming. Simply use the "+" and "-" keys to set the duration, programming starts again from
zero immediately. When you set to 12, then press "+", the displayed value will be zero, then press "-"
the value will return to 12.
3. If there is no activity for 5 seconds or if you press any other keys than "S" \ "+" \ "-" for 5 seconds, you
will exit the time setting mode and Lights will not flash.
4. If you set the timer to non-zero, the timer will start (not displayed), when set to 0, the unit will enter
standby mode immediately.
5. If the setting is zero, this means no time setting.
6. When the "S" button is pressed three times, the nixie tube is displayed normally.
7. Normal display (Nixie tube): if there is no time setting, the nixie tube continuously displays the ambient
humidity between 0 and 99. In the case of a timer setting, it shows the ambient humidity during the 10
First seconds, and then displays the timer and the remaining time for 10 seconds, cyclically.
c) Humidity setting
1. When the unit is not in any mode, you can press the "+" and "-" keys to adjust the humidity mode:
 Low: low light indicator (Led_ Lo);
 Moderate: both low and moderate light indicators (Led_ Lo and Led_ Mid);
 High: all light indicators (Led_Lo, Led_Mid, Led_Hi).
Humidity display
2. The volume of steam according to the humidity mode:
 High: 100% corresponds to a humidification of 300 ml / h
 Moderate: 70% corresponds to a humidification of 210 ml / h
 Low: 40% corresponds to a humidification of 120 ml / h
Low
Medium High
25