Precautions Before Installation - Samsung SADT-100CM Manuel D'installation

Summary
The Ceiling Mounted Adaptor (SADT-100CM) is the adapter used
for the installation of the Smartdome Camera (indoor or outdoor
housing) on concrete ceilings..

Precautions Before Installation

•
Make sure that the proposed location can support the combined weights (about 8kg)
of the Ceiling Mounted Adaptor, Outdoor Housing and Smartdome Camera.
•
The product is designed to use M10 anchor bolts or anchor nuts.
•
When installing the product on a concrete wall, use M10 anchor bolts/nuts together
with plain and spring washers.
•
Each anchor bolt must be capable of withstanding an extraction force of 700 kg.
•
When installing the product outdoors, use interlocking devices made of stainless steel.
•
This goods should only be installed by a qualified technician using approved materials
and wiring practices in accordance with national, state, and local electrical code.
1
Installation
Select a location that is capable of supporting four times the
1
total weight of the product to be installed (about 32 kg).
2 Use the Ceiling Mount Adaptor to mark the positions for the
M10 anchor bolts or nuts, drill the holes and install the anchor
bolts/nuts.
If the cable pipe is installed inside the wall:
3
1) Pull the power cable, video-out cable and
communications cable out through the holes
of the Ceiling Mounted Adaptor. Take care not to
damage avoid damage tothe cable sleeving.
2) Securely fasten the Ceiling Mounted Adaptor
using the anchor bolts/nuts.
If the cable pipe is installed on the wall:
1) Make a hole of 21mm in diameter on the outside of the pipe (on the side
and near the tip) and install a PG13.5 cable gland.
2) Pull the cables out to the pipe through the cable gland.
3) Attach the 1.5" NPT pipe to the Ceiling Mounted Adaptor. Make sure to
wind Teflon tape around the screws for watertightness.
4) Securely fasten the Ceiling Mounted Adaptor using the anchor bolts/nuts.
•
Positions for the hole (unit: mm)
GB
2