Winner Sat V3AA Manuel D'utilisation page 20

Connecting the Receiver
How To Receive Wireless Audio/Video on Your TV
There are two ways to receiver wireless audio/video signals on your remote TV (TV in another location
such as in bedroom, kitchen)
. Connect the receiver directly to the remote TV.
. Connect the receiver to a VCR, which is then connected to the TV.
If your TV has picture-in-picture capabilities, you can view any image transmitted by system, such as your
sleeping baby, in a small inset picture while enjoying other programming on the rest of the screen.
Consult the owner's manual of your TV for instructions on using these capabilities.
Connecting Receiver Directly to Remote TV
1. If your TV has A/V jacks, connect one set of A/V cables (or SCART cable labeled "RECEIVER") to the
TV's A/V jacks and to the A/V output jacks on the receiver (X300A or X301A). Be sure the yellow, red and
white plugs match the yellow, red and white jacks on both the TV and the receiver.
If the TV has only a single jack for audio input, connect the white plug to that jack.
AUDIO
CHANNEL
ON OFF
1 2 3 4
L R VIDEO DC 9V
UHF ANT