Winner Sat V3AA Manuel D'utilisation page 19

How To Transmit Audio/Video from Your VCR
1. Connect one set of audio/video(A/V) cables (or SCART cable labeled "TRANSMITTER") to the A/V
jacks of the transmitter and to the A/V output jacks (or SCART connector) on the back of your VCR. Be
sure the yellow, red and white plugs match the yellow, red and white jacks on both the VCR and the
transmitter. If the VCR has only one output for audio (mono sound only), connect the white plug to that
single audio output and to transmitter's AUDIO LEFT jack.
2. Plug one end of the power adapter into the back of the transmitter and the other end into any 230-volt
wall outlet (or 120-volt). Use only the adapter provided.
NOTE: make sure the ON/OFF switch is in the 「OFF」position before connection.3. If your VCR has only
one set of A/V output jacks and you want to use it with a nearby TV, connect 75 ohm RF coaxial cable
from the modulator signal OUT port on your VCR to the VHF/UHF IN port on your TV. (Note: In order to
also view cable programs on that TV, connect your incoming cable TV source to the IN port of the VCR.)
4. Locate and orient the transmitter for best performance of transmitter.
AUDIO
CHANNEL
IR JACK 1 2 3 4
L R VIDEO DC 9V
UHF ANT
ON OFF