Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
INSTALLATION
Installation must be carried out by a licensed and authorised person only.
Never attempt to carry out an installation while the electrical power is switched
on.
Remove all protective plastic from the heater before installation.
Ensure that you refer to the installation precautions under IMPORTANT SAFETY
INSTRUCTIONS before starting to mount the heater.
Only connect the appliance to a power supply that conforms to the
specification stated on rating plate.
For installation use only the supplied accessories or original accessories
approved by the manufacturer.
This heater must be installed according to the minimum installation clearances
shown in the diagrams.
A minimum safety distance of 150cm should always be left in front of the
appliance.
This heater must be mounted at a minimum of 180cm above the floor.
The heater should always have a minimum clearance of 50cm from a ceiling
and adjacent walls.
Mark and drill the mounting holes on the wall. Attach the mounting bracket to
the wall.
Bring the heater up to mounting bracket. Insert M6 bolts in the slots on the
bracket. Lock into position with M6 nuts.
Rotate the heater to require angle and lock into position with the bolt and nut
on the wall bracket.
Do not position the heater on the wall at an angle of less than 45°.
Do not place articles on or against this appliance.
7
Publicité
Table des Matières
