Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Ensure that the spring is aligned centrally to the universal clamping disc and that the
grippers are evenly arranged!
u
4
3
When the strut has been secured with the grippers
(guide bolt
in outer slot). If possible, both brakes should be opposite to one another. Position
2
the rubberised surface of the brakes over the still bearing on end of the spring wire and slightly
tighten the screws
4
berised brakes onto the spring wire by slightly tightening the spindles
HAZET ratcheting combination wrench 606-13 to secure the spring against twisting in relation to
the universal clamping disc.
28
3
Design and function
V
6
e.g. with the HAZET ratcheting combination wrench 606-13. Lower the rub-
4
Slightly tighten the screws
with the HAZET ratcheting combination
wrench 606-13, in order to prevent unin-
tentional shifting during operation.
, swivel the brakes
3
u
4
5
1
4
into the last spring coil
1
(3.5 Nm), e. g. with the
5
V
, e. g.
2
Publicité
Table des Matières
