Prodipe ST1 Ludovic Lanen Manuel Utilisateur page 7

Frequency Response Graph:
Connecting and Disconnecting the Microphone Cable:
1. Insert the XLR connector into the microphone. If necessary, rotate the connector to align the key on the
connector and the groove in the microphone. Push the connector into the microphone until clicks.
2. To disconnect the cable and microphone, grasp the connector while depressing the tab. Pull the
connector away from the microphone.
Operation:
How to use switch:
Prodipe ST1
A. Low frequency attenuation:
"- " no attenuation;
"┌" – it can balance the low frequency rising effect of short distance pickup and reduce the feedback as well as
protect from howling.
B. Sensitivity attenuation:
"0 " – no attenuation;
"-10dB" – it fixes the sensitivity on –10dB level, shortens the pickup distance, eliminates the noise: this function is
usually used for high SPL and large dynamic pickup occasions (i.e. the pickup of low frequencies of small
instruments of symphony orchestra);
Prodipe and its distributors decline all responsibility for any damage caused by using this appliance in a
way that does not conform to the conditions of use as set out above.
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2016 IPE Music/Prodipe
Page 7