YORKVILLE YSM Série Manuel De L'utilisateur page 6

YSM
5. Low Frequency Control Settings (YSM6 and YSM8)
The default setting for the LF (low frequency) is 0. As an example, if the monitors are
placed in the middle of a room and more low end response is needed, set the select
switch to +1.5 A. As another example, if your monitors are placed against the back wall
as shown in the diagram below, it is recommended that you set the LF setting to -1.
Accordingly, if the monitors are placed in the corner of the room, set to -2.
LF Presets
+1.5 -1 -2
0
Full Space Placement 1/2 Space Placement 1/4 Space Placement
(full area) (against the wall) (in corner)
6. Bi-Amplification
The common term is bi-amplification, a process which uses two power amplifiers and
an electronically accurate 'active' crossover network. This type of crossover network
divides the signal much more precisely than traditional passive crossover networks. All
three monitors, the YSM5, YSM6 and YSM8 use bi-amplification, an amplifier dedicated
for the tweeter and another for the woofer.
4