EINHELL GE-EC 720 T Mode D'emploi D'origine page 22

Anleitung_GE_EC_720_T_SPK7__ 13.03.13 08:47 Seite 22
GB
Cause
Chainsaw does not work at all No power supply
Chainsaw operates
intermittently
Saw chain dry
Chain/guide rail hot
Chainsaw juddering, vibrating
or not sawing properly
22
Fault
Defective mains outlet
Power extension cable damaged
Defective fuse
Power cable damaged
Loose connection (external)
Loose connection (internal)
ON/OFF switch defective
No oil in the tank
Oil tank cap breather blocked
Oil outlet blocked
No oil in the tank
Oil tank cap breather blocked
Oil outlet blocked
Blunt chain
Chain tension too loose
Blunt chain
Worn chain
Saw teeth pointing in the wrong
direction
Remedy
Check the power supply
Try an alternative source of electrical
power, replace if necessary
Check the cable and replace as required
Replace the fuse
Consult a specialist workshop
Consult a specialist workshop
Consult a specialist workshop
Consult a specialist workshop
Fill up with oil
Clean the oil tank cap
Clear the oil outlet
Fill up with oil
Clean the oil tank cap
Clear the oil outlet
Re-sharpen or replace the chain
Adjust the chain tension
Re-sharpen or replace the chain
Replace the chain
Reinstall the saw chain with the teeth
facing in the correct direction