Care & Maintenance; Cleaning; Storing; Resetting The Motor Thermostat - shark Ninja BN700 Série Guide De L'utilisateur

CARE & MAINTENANCE

CLEANING

Separate all parts. Wash container in warm,
soapy water with a soft cloth.
• Hand-Washing
Wash blade assembly in warm, soapy
water using a dishwashing utensil with
a handle to avoid direct contact with
the blades. Exercise care when handling
blade assembly as the blades are sharp.
Thoroughly rinse and air-dry all parts.
• Dishwasher
All attachments are dishwasher safe. It is
recommended that the lid, container, and
blade assembly be placed on the top rack
of the dishwasher ONLY. Ensure the blade
assembly is removed from the container
before placing in the dishwasher. Exercise
care when handling blade assembly.
• Motor Base
Turn off the unit and unplug the motor
base before cleaning. Wipe motor base
with a clean, damp cloth.
DO NOT use abrasive cloths, pads, or
brushes to clean the base.
12 ninjakitchen.com

STORING

Wrap the power cord around the cord wrap
on the back of the motor base. Store the
unit upright and store the blade assembly
inside or attached to the container with the
lid locked in place
DO NOT stack items on top of the container.
Store any remaining attachments alongside
the unit or in a cabinet where they will not
be damaged or create a hazard.
RESETTING THE MOTOR
This unit features a unique safety system
that prevents damage to the motor and
drive system should you inadvertently
overload the it. If the unit is overloaded, the
motor will be temporarily disabled. Should
this occur, follow the reset procedure below.
1 Unplug the unit from the electrical outlet.
2 Allow the unit to cool for approximately
15 minutes.
3 Remove the container's lid and blade
assembly. Empty the container and
ensure no ingredients are jamming the
blade assembly.
IMPORTANT: Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.
If your unit needs servicing, please call
Customer Service at 1-877-646-5288.
So we may better assist you, please register
your product online at registeryourninja.com
and have the product on hand when you call.

ORDERING REPLACEMENT PARTS

To order additional parts and attachments,
visit ninjaaccessories.com.

TROUBLESHOOTING GUIDE

WARNING: To reduce the risk of shock and unintended operation,
turn power off and unplug unit before troubleshooting�
The LEDs on the control panel are flashing�
•
If the unit is plugged in and powered on, but there is no container installed, the LEDs on the
control panel will flash. Install a container and the available program buttons will illuminate,
indicating the unit is ready for use.
Unit doesn't mix well; ingredients get stuck�
•
Using the Auto-iQ® programs is the easiest way to achieve great results. The pulses
and pauses allow the ingredients to settle toward the blade assembly. If ingredients are
routinely getting stuck, adding some liquid will usually help.
Unit moves on counter while blending�
•
Make sure the surface and feet of the unit are clean and dry.
Unit doesn't create snow from solid ice�
•
DO NOT use ice that has been sitting out or has started to melt. Use ice straight from
the freezer.
•
Start with a few pulses and then use a continuous blending cycle.
The pitcher lid handle will not fold down�
•
If not attached to the pitcher, the handle will not fold down. For storage, place the lid on the
pitcher and press down on the handle until it clicks into place.
13
ninjakitchen.com