Putting Into Operation; Inserting / Changing Batteries; Connecting The Mains Adapter - VenenWalker basic HNS018839 Mode D'emploi

EN

Putting Into Operation

The device can be operated either with batteries or with the mains adapter supplied.
• Before use, insert the batteries or connect the mains adapter.

Inserting / Changing Batteries

The battery compartment is on the rear of the control unit. You will need four 1.5 volt AA
batteries. Use only standard batteries, never rechargeable batteries!
The demo batteries supplied only have enough power to operate the device for approx.
20 minutes.
1. Open the battery compartment.
2. Insert four 1.5 volt AA type batteries. Ensure the correct polarity (+/-) when inserting
the batteries.
3. Close the battery compartment.
Your VenenWalker

Connecting the Mains Adapter

06019_de-en-fr-nl-it_A5_V2.indb 28 06019_de-en-fr-nl-it_A5_V2.indb 28
» basic « is now ready for use!
®
1. Connect the mains adapter to the control unit. The
connection is located below the area for opening
the battery compartment.
2. Connect the mains adapter to a properly installed
socket which corresponds to the technical data of
the device (see the "Technical Data" chapter).
Your VenenWalker
28
» basic « is now ready for use!
®
15.04.2021 15:21:53 15.04.2021 15:21:53