Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
•
The fully assembled support beam is very heavy and should be lifted into place by two people.
•
Loosen the grip knobs (6) to allow the assemblies to slide and then locate the rubber feet into the
gutters of the vehicle's front wing panels or close to the suspension strut towers.
•
Note: refer to the manufacturer's handbook to identify engine lifting brackets.
•
Drop the adjustable screw assemblies through the slot in the main beam in positions adjacent to the
engine lifting points
•
Attach the ends of the chain to the lifting brackets on the engine.
•
The chains may be attached to the lifting hooks in a single or looped chain configuration.
•
Lower the adjustable screws and hook the chains around the hooks. In all cases ensure that at least one
link of the chain is hooked over the lifting hooks.
•
Tighten both grip knobs (6).
•
Progressively rotate the lifting handles (2) clockwise to tighten the chains and support the engine.
•
On completion of the maintenance task, rotate the lifting handles anticlockwise to release the tension on
the chains.
•
Unhook the chains, loosen both grips (6) and remove the engine support from the vehicle.
•
Remove the chains from the engine lifting points.
Refer to fig.1
Item Description
1
Beam
2
lifting handle
3
Adjustable screw
4
standing block
5
Foot
6
Grip knob
7
Washer 13mm Internal Ø
8
Washer 22mm Internal Ø
9
chain
10
M10 x 30 Bolt 16mm & locknut
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
fig.1
T: 00352/26908036 – F: 00352/26908040
NEEST-03
Publicité
Table des Matières
