RIDGID HB-382 Mode D'emploi

Hydraulic Bender Turnable Tripod Instructions
WARNING
Read these instructions and the warnings and instruc-
tions for all equipment being used before using to
reduce the risk of serious personal injury.
• Support pipe. Failure to properly support the pipe can cause
bender tipping, falling pipe, and serious injury.
If you have any question concerning this RIDGID
– Contact your local RIDGID distributor.
– Visit www.RIDGID.com or www.RIDGID.eu to find your
local RIDGID contact point.
– Contact RIDGID Technical Services Department at
rtctechser vices@emerson.com, or in the U.S. and
Canada call (800) 519-3456.
Description
The RIDGID ® Hydraulic Bender Turnable Tripod is used with
the RIDGID Hydraulic Pipe Benders (Models HB-382, HB-
382E, HB-383 and HB-383E). It increases pipe bender height
for convenience while operating and allows bender rotation
during operation.
Bending Frame
Tripod Bracket
Locking Bolt
Leg Pin
Leg
Figure 1 – Assembled Hydraulic Bender with Turnable Tripod
Inspection/Maintenance
The Turnable Tripod should be inspected before each use for
wear or damage that could affect safe use. Clean as needed
to aid inspection. Make sure the Turnable Tripod is complete
Printed in U.S.A.
EC38304
product:
®
Mounting
Plate
Cylinder
and properly assembled. If any problems are found, do not
use until the problems are corrected. Lubricate all moving
parts/joints as needed with a light lubricating oil, wipe up
excess oil.
Turnable Tripod Assembly and
Operation
1. Locate a clear, level, stable location to set up the
hydraulic bender and tripod.
2. Attach the tripod mounting plate to the bottom of the
bending frame with supplied fasteners and firmly tighten.
3. Securely assemble the legs to the tripod bracket with the
supplied pins. Place on floor and confirm stable. Loosen
the locking bolt to allow the mounting plate to be insert-
ed.
4. Fully insert the mounting plate into the tripod bracket,
aligning the bending frame with two legs. Tighten the
locking bolt to hold in place.
5. Assemble the Hydraulic Bender per the manual instruc-
tions.
6. If needed, the locking bolt can be loosened during use
to allow the bender to rotate. If bender rotation is not
needed, align the cylinder with a leg and tighten the
locking bolt.
7. Always properly support the pipe to prevent tipping of
the pipe and bender during use.
Trépied à plateau tournant pour
cintreuse hydraulique : Mode
d'emploi
AVERTISSEMENT
Afin de limiter les risques de grave blessure cor-
porelle, familiarisez-vous avec le présent mode d'em -
ploi et ceux de l'ensemble du matériel utilisé avant
d'employer ce dispositif.
• Soutien des tuyaux. Les tuyaux doivent être soutenus de
manière appropriée afin de limiter les risques de chute du
tuyau, de renversement de la cintreuse et de graves
blessures corporelles.
En cas de questions visant ce produit RIDGID
– Consulter le distributeur RIDGID le plus proche.
– Visitez le site www.RIDGID.com ou www.RIDGID.eu afin
d'obtenir les coordonnées du représentant RIDGID le
plus proche.
RIDGID ®
7/11
® , veuillez :
944-732-627.10
REV. A